DecoderPro® Manual
Setup JMRI
Getting Started
Using DecoderPro
DecoderPro Programming Modes
The Basic Programmer
The Comprehensive Programmer
Advanced Features
DecoderPro® Main Window
Error Messages

DecoderPro® Main Window

JMRI® Throttle Window - Address Panel


Address Panel

Throttle address frame

Primary use is to identify the decoders address, and to Set, Dispatch or Release the identified address in your DCC Controller. Locomotive addresses may be entered by one of two methods: typed into text box or use drop-down list to select locomotive from your roster. If you have added Function labels, to your Roster, the label text from the Roster will be displayed on the throttle function buttons.

Click on the Set button to send the address to your system to make this throttle active for the selected locomotive..

The Dispatch button is used to dispatch the locomotive which releases the throttle for that address so that it can be acquired by another throttle

The Release button is used to release the address from your system.

The Program button opens the Programmer for the locomotive selected in ops-mode (Programming on the Main) Only active when roster entry is used to select the address for the throttle.

Any of the buttons may be grayed out depending on the status of your system.