DecoderPro®
Installing JMRI
Getting Started
Starting DecoderPro
DecoderPro Programming Modes
The Basic Programmer
The Comprehensive Programmer
The Advanced Programmer
DecoderPro Main Window
Creating a New Decoder Definition
Error Messages

Decoder Definition

Testing

Previous | Next

Back to Index


Testing the decoder definition

At this point, you've created a new configuration file! You can check it for syntax by selecting the Check XML File item from the Debug menu. The Open dialog is displayed; select your file and click . If all is well, a dialog box will display that says "OK". If not, you'll get a completely incomprehensible error message. About the only useful part of that message is the line number. Re-open the editor to that line and try to see what's wrong with the syntax.

Once you have a decoder definition file that checks out for syntax, you need to try it in DecoderPro. Your new file should copied into the jmri decoders folder (windows C:\Program Files\JMRI\xml\decoders).

After including in your decoder definitions for DecoderPro® you will want to test the definition on an actual decoder installation using the Programmers available to you. When satisfied that it works as expected, then follow the next step.

When you are happy with your definition, you’ll probably want to share it with the JMRI world, so next we’ll look at submitting the definition to JMRI for inclusion in the next release.


Previous | Next

Back to Index