familyname=Series 7 Boards
manufacturer=Digitrax
definitionSource=JMRI
LOCONETBD7OPSWMODECV=1,"Board Address"
CV=7,"Device Type"
CV=8,"Device Manufacturer (NMRA number) "
CV=9,"Serial Number"
CV=11,","0","Normal Sensitivity","1","Higher Sensitivity","2","Lower Sensitivity","3","(unknown sensitivity)"Detection uses "
CV=11,","","Normal","","Slow"Detection speed is "
CV=12,","","Forces all detection to "occupied"","","has no effect on occupancy reporting"Track power "off" "
CVs<html>The "CV" column in the table above shows CV
                        numbers, not the Op Switch number.<p>To see those, hover
                        your mouse over a variable on the OpSw Settings pane.
                        <p>CVs 1 and 2 are the low and high (respectively) 8-bit
                        "Base Address" values.<p>The "Base Address" is practically
                        limited to 2040, max.<p>The JMRI "Roster" tool and its
                        Roster entries <em> cannot</em> change the
                        "Base Address".
                    Basic<html>
                <p>This roster entry will only access the specified
                board if the Base Address specified above <br>was
                correctly entered when the roster entry was first created.
                You <em>cannot</em> change it in the Roster Entry.
            </html>OpSw Settings<html><h2>Detection SettingsNotes<html><h2>Notes:<html><ul>
              <li>When accessing CVs for the BDL716 device, its CVs are
                  implemented as if they are in <br;>the LocoNet "switch" address
                  space, even though the BDL716 <em>does not</em>
                  implement <br>any "switches".</li>
              <li>The BDL716 might be accessible at <em>any of the
                  "Switch" numbers</em> that <br;>correspond to the BDL716's 
                  "Sensor" addresses.</li>
              <li>The BDL716's CVs can (mistakenly!) be mapped to a "Base 
                  Address" that "overlaps" <br;>another device on this 
                  LocoNet connection, or via a DCC Track-connected device.  <br;>When 
                  programming with this roster entry, it might cause other 
                  devices to be <br;>mistakenly configured.</li>
              <li>Because of the notes above, </em>it is recommended</em>
                  that this BDL716 roster entry <br;>should be set to the 
                  BDL716's "Base Address" setting, and the Base Address <br;>
                  setting should not conflict with other BDL716 addresses.
              <li>The BDL716 device's "Sensor" addresses are from the "Base 
                  Address" to the <br;>"Base Address" + 15.</li>
              </ul></html>