Decoder Family: Series 7 Boards

LOCONETBD7OPSWMODE

CV Definitions:

CVNamePositionsValues
1
    7
      8
        9VVVVVVVV
          11XXXXVVVV
          11XXVXXXXX
          12XXXXXXVX
          12XXXXXVXX
          12XXVXXXXX
          12XVXXXXXX
          0.25
            0.26
              0.27
                0.28
                  1.25
                    1.26
                      1.27
                        1.28
                          2.25
                            2.26
                              2.27
                                2.28
                                  3.25
                                    3.26
                                      3.27
                                        3.28
                                          4.25
                                            4.26
                                              4.27
                                                4.28
                                                  5.25
                                                    5.26
                                                      5.27
                                                        5.28
                                                          6.25
                                                            6.26
                                                              6.27
                                                                6.28
                                                                  7.25
                                                                    7.26
                                                                      7.27
                                                                        7.28
                                                                          CVs <html><p>CVs 1 and 2 are the low and high (respectively) 8-bit "Base Address" values.<p>The "Base Address" is practically limited to 2029 (in "2-position servo" mode), or <p>2025 (in "3-position Servo" mode).<p>The "Roster" tool and its Roster entries <em> cannot</em> change the "Base Address". Basic <html> <p>This roster entry will only access the specified board if the Base Address specified above <br>was correctly entered when the roster entry was first created. You <em>cannot</em> change it in the Roster Entry. </html> OpSw Settings <html><span style="color: black;"><h2><strong>Output Controls Characteristics</strong></h2></html> <html><span style="color: black;"><p><h2><strong>Output Controls Characteristics</strong></h2></html> Servos <html><span style="color: black;"><h2><strong>Servo Characteristics</strong></h2></html> Output Type eq 2 <html><span style="color: black;"><p> "Aproach" and "Approach Medium" settings are only used<p> when operating in "Three-position" mode. Those values are<p> irrelevant for "Two-position" Servo mode and are not shown<p> here.</html>
                                                                          This page was produced by JMRI.

                                                                          Copyright © 1997-2025 JMRI Community.

                                                                          JMRI, DecoderPro, PanelPro, DispatcherPro and associated logos are our trademarks.

                                                                          Additional information on copyright, trademarks and licenses is linked here.