Primary Address Short address Start Volts A value of 255 corresponds to 100% Acceleration Rate Deceleration Rate Max Volts Mid Volts Version ID Manufacturer ID Motor Drive Frequency 00 is fastest, 255 is slowest Long Address Advanced Consist address forward reverse Advanced Consist direction No Yes Advanced Consist Function 1 Override No Yes Advanced Consist Function 2 Override No Yes Advanced Consist Function 3 Override No Yes Advanced Consist Function 4 Override No Yes Advanced Consist Function 5 Override No Yes Advanced Consist Function 6 Override No Yes Advanced Consist Function 7 Override No Yes Advanced Consist Function 8 Override No Yes Advanced Consist Function 0 Override forward reverse Normal direction of motion 14 28/128 Speed steps Off On Analog conversion mode Use Vstart, Vmid, Vhigh Use Table Use Speed Table 2 digit addressing 4 digit addressing Addressing Mode Forward light F0F effect generated Forward light F0F behavior Reverse light F0R effect generated Reverse light F0R behavior Function 1 effect generated Function 1 behavior Function 2 effect generated Function 2 behavior Function 3 effect generated Function 3 behavior Function 4 effect generated Function 4 behavior Function 5 effect generated Function 5 behavior Function 6 effect generated Function 6 behavior Static compensation for speed stabilization Factory default is 128, no effect until droop (CV57) set Dynamic compensation for speed stabilization Factory default is 48, no effect until droop (CV57) set Solo operation droop compensation for speed stabilization 0 is compenstation off, 15 is full on, typical value is 5 Advanced consist droop compensation for speed stabilization 0 is compenstation off, 15 is full on, typical value is 5 F5 has no effect on speed compensation F5 On disables speed compensation Speed Compensation Control Off On Digitrax Transponding Normal DC motor Split field/AC motor Split field motor Enabled Disabled Vstart/Vmid/Vfull in 128 step mode Enabled Disabled Short-circuit protection Undocumented feature, occasionally requested by Digitrax tech support Lamp keep-alive voltage 0 is no keep-alive, use with LEDs FX rate adjust 0 is fast, 15 is slow, 4 is recommended for start Ditch light hold-over time 0 is none, 40 is realistic 5 seconds, 255 is about 20 seconds Disabled Enabled Switching speed enabled by F6 Enabled Disabled Torque compensation Enabled Disabled Decoder Lock Feature Decoder Lock ID number Kick Start Forward Trim Reverse Trim User Private ID #1 User Private ID #2 Speed Table Digitrax